Iowa City · Coralville · North Liberty

Sump Pump Installation & Replacement in Iowa City, IA

Your sump pump has one job, and it has to do it during the worst storm of the year, usually at night, usually when the power is flickering. If yours is old, loud, running nonstop or you've never lifted the lid to see what's in there, this page is for you.

Get matched with a local pro

Tell us what you’re seeing. It takes about a minute.

Free, no obligation. Your request may be shared with independent local providers who can help.

Signs your sump pump needs attention

  • It runs nonstop, or cycles on and off every few seconds
  • It doesn't kick on at all during heavy rain
  • Grinding, rattling or a loud thunk when it shuts off
  • Rust, silt or debris in the pit
  • The pump is seven to ten years old or more
  • The discharge line freezes in winter

What goes into a good sump install

  • The pit. Properly sized basin set below the slab, with a sealed lid to keep radon, humidity and smell out of the house.
  • The pump. Submersible pumps are quieter and sit down in the pit. Pedestal pumps are cheaper and easier to reach but louder. Submersible is the usual pick, especially in finished basements.
  • The check valve. Stops water in the discharge line from falling back into the pit. It's the thunk you hear when the pump stops.
  • The discharge line. Sloped, sealed, and ending well away from the foundation, with a way for water to get out if the end ices over. Never into the sanitary sewer.
Parts of a sump pump system Cross-section of a basement floor with a sump pit. A drain pipe feeds water into the pit. A submersible pump with a float switch sits in the pit. The discharge line rises through a check valve, runs out through the wall and ends away from the foundation. A battery backup and a high-water alarm sit on the basement floor. + ! Discharge line goes up and out Check valve stops backflow Drain pipe feeds the pit Pump with float switch Out, away from the house Battery backup runs pump in outage Alarm warns early
A sump system is more than a pump. Water enters the pit, the float switch turns the pump on, the check valve keeps pumped water from draining back, and the discharge line sends it outside. A battery backup and an alarm cover the storm-and-outage scenario.

How a sump install goes

  1. Pick the low spot The pit goes where water naturally collects, or at the end of the interior drain.
  2. Break the slab and set the liner A small hole is cut, a pit is dug and the liner is set level and backfilled with stone.
  3. Set the pump on a solid base The pump sits clear of silt and the float has room to move without touching the walls.
  4. Add the check valve It goes on the discharge line so pumped water cannot run back into the pit.
  5. Run the discharge line out The line slopes away, exits the house sealed and ends well away from the foundation, never into the sanitary sewer.
  6. Add backup and an alarm A battery backup and a high-water alarm cover the storm-and-outage case, then everything is tested with water.

Backup power matters here

A pump needs electricity, and storms that flood basements often take out power too. There are a few ways to cover that:

  • Battery backup pump. Sits in the pit next to the main pump and runs on its own battery. Run time depends on the battery and how hard the water is coming in.
  • Water-powered backup. Uses city water pressure, no battery. Not an option if you're on a well, and it uses a lot of water.
  • Generator. Covers the pump along with everything else you need during an outage.
  • High-water alarm. Cheap, and it gives you a heads-up before water hits the floor.

A safety note

Don't reach into the pit to test the float with the pump plugged in. Unplug it first, or have a pro do it.

Questions to ask any contractor before you hire

  • Where is the water coming from? They should be able to point to the path and explain why, not just quote a system.
  • How many feet of drain, and what size pump? Compare scope, not just the total.
  • Where does the sump discharge? Away from the foundation, and never into the sanitary sewer.
  • Is there battery backup? Storms that flood basements often knock out power too.
  • What does the quote leave out? Finished-wall work, mold, structural repairs and radon are usually separate.
  • What happens if it fails? Get any warranty in writing and ask what it covers.

What sump pump installation typically costs

Ballpark ranges for the Iowa City area. These aren’t quotes. A contractor prices your basement after they see it.

JobTypical rangeNotes
Sump pump replacement $600 – $1,800 Pump, check valve and labor. Higher end for quality submersibles and discharge fixes.
New sump pit and pump $1,500 – $3,500 Includes cutting the slab, new basin, sealed lid and discharge line.
Battery backup add-on $700 – $1,800 Depends on battery size and whether the primary pump also needs replacing.

Read the full pricing guide →

How getting matched works

  1. Tell us what’s going onFill out the short form with your ZIP code and what you’re seeing. It takes about a minute. A contractor may ask for photos when they follow up.
  2. We match you with a local contractorWe send your request to a waterproofing contractor who works in your town, so you’re talking to someone local.
  3. They look at it and quoteThe contractor looks at your basement and gives you a scope and a price. Ask for it in writing, and ask what it leaves out.
  4. You decideThere’s no cost to request a match and no obligation to hire anyone. Compare quotes if you like.

Common questions

How long do sump pumps last?

Typically seven to ten years, and less if the pump cycles constantly. If yours is past that, replacing it before it fails during a storm is cheaper than the cleanup after.

What size sump pump do I need?

Most homes here do fine with a one-third horsepower submersible. Wetter lots or a high water table may call for a half horsepower or a second pump. Pump size is only part of the picture; discharge line size and how high the water has to be lifted matter too.

My sump pump runs all the time. Is that bad?

Depends on the weather. In spring or after a storm, running for a while is normal. If it runs nonstop in dry weather, the cause could be a stuck float, a failed check valve, a high water table or a plumbing leak. Get it looked at.

Where we match homeowners for sump pump installation

Wet basement? Tell us what you’re seeing.

Send your ZIP code and a few details. We’ll match you with a local waterproofing contractor who can look at it and give you a quote. It’s free to request, with no obligation.

Serving Iowa City, Coralville, North Liberty, Tiffin, University Heights and Solon.

Free, no obligation. Your request may be shared with independent local providers who can help.

Get matched with a local pro